Log in
Search
Latest topics
» Introducing the new - "QZ" RR-1by Boats13 Today at 10:19 am
» STUKA bomb dimentions needed
by latole Today at 9:36 am
» Indexing COX cylinders
by davidll1984 Today at 7:56 am
» Another of C.T. engines cleaned ---- Cox Tee Dee .09 --- Just today (3/26/2024) more Cox parts
by Yabby Today at 7:47 am
» Introducing our Cox .049 TD Engines
by Yabby Today at 6:33 am
» 1/2a Skyray plans?
by 944_Jim Yesterday at 10:14 pm
» Postage stamp backplates
by JPvelo Yesterday at 8:52 pm
» my attempt at making an exhaust throttle for Cox .049
by roddie Yesterday at 8:20 pm
» Cosmic Winds, - Big Guy, Little Guys, Silver Guy and Wounded Guy.
by rsv1cox Yesterday at 5:18 pm
» My friend Ramón, his Cox .09 & Cox .010
by MauricioB Yesterday at 12:31 pm
» Parts Cox TD-4
by rsv1cox Yesterday at 8:40 am
» On ebay a very special Cox engine
by davidll1984 Yesterday at 6:32 am
cox .010 crank stuck in crankcase
Page 1 of 1
cox .010 crank stuck in crankcase
Hey i am doing a diesel conversion for my cox .010 and today tried to get the crank out co i could heat treat it but it apears to be stuck does any one have some advice. This has never happened before ans its with all my .010 engines but all my others the cranks come out no problem?
ps sorry moderator i put this in the wrong topic how do i move it?
ps sorry moderator i put this in the wrong topic how do i move it?
Re: cox .010 crank stuck in crankcase
Sorry about the late response...
Is the prop driveplate stuck on or is the crankshaft itself stuck?
The crankshaft should just come right out once the driveplate is off, you could try tapping it out with a small hammer. I have never removed a .010 crank but I have built a .010 before and the crankshaft just slid into place like all the other cox engines. You could try heating it, just don't melt the plastic carb body. If you are going to tap it out, wrap the crankcase in a towel so you don't scuff it and then put it in a vice. Screw a prop screw into the crank and then tape the head of the screw.
Is the prop driveplate stuck on or is the crankshaft itself stuck?
The crankshaft should just come right out once the driveplate is off, you could try tapping it out with a small hammer. I have never removed a .010 crank but I have built a .010 before and the crankshaft just slid into place like all the other cox engines. You could try heating it, just don't melt the plastic carb body. If you are going to tap it out, wrap the crankcase in a towel so you don't scuff it and then put it in a vice. Screw a prop screw into the crank and then tape the head of the screw.
Similar topics
» Crankcase assembly tool stuck!!
» Stuck TD 0.9
» Need help identifying a TD .049 crank / crankcase
» Crank VS Crankcase Help Needed Please
» Tee Dee Backplate Stuck
» Stuck TD 0.9
» Need help identifying a TD .049 crank / crankcase
» Crank VS Crankcase Help Needed Please
» Tee Dee Backplate Stuck
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum