Re: S.A.D Open for Membership

nitroairplane Wed Dec 21, 2011 5:13 am

S.A.D Open for Membership - Page 4 Photo-10

The tail got sat on before I got to fly it then i repaired it and it ended up being too tail heavy and oyu know the rest is obvious.

Ivanhoe Wed Dec 21, 2011 6:47 am

nitroairplane wrote:

The tail got sat on before I got to fly it then i repaired it and it ended up being too tail heavy and oyu know the rest is obvious.

Oh that's certainly a

S.A.D Open for Membership - Page 4 Small_12

nitroairplane Wed Dec 21, 2011 9:08 am

lol I know and I never got to fly her properly Sad

speaking of small 3D planes I flew my Extra 300 today!

microflitedude Wed Dec 21, 2011 9:33 am

nitroairplane wrote:lol I know and I never got to fly her properly
speaking of small 3D planes I flew my Extra 300 today!

How'd she do?

nitroairplane Wed Dec 21, 2011 9:44 am

Good and after 1/2 a battery i put the throws up to 100% and it was great fun and of course learning 3D one must crash and I did several times and the wing strut came loose but some foam safe CA fixed that.
When this becomes to repaired to fly 3d which one day it will I am sure I may go to that Yak 54 you have.

microflitedude Wed Dec 21, 2011 10:00 am

I got the one here, last picture. I was supposed to get the other one, whcih was new, but he got mixed up and sent me the heavily used one. To make up he sent me a new airframe. Smile

http://www.rcgroups.com/forums/showthread.php?t=1448589

nitroairplane Wed Dec 21, 2011 10:07 am

They look good.
Do you know if he has plans available,or a plan for a plane that is just foam and no covering?

microflitedude Wed Dec 21, 2011 11:16 am

nitroairplane wrote:They look good.
Do you know if he has plans available,or a plan for a plane that is just foam and no covering?

I doubt he would give them to anyone. My other frame is unassembled, I could trace it...

nitroairplane Wed Dec 21, 2011 12:29 pm

microflitedude wrote:
nitroairplane wrote:They look good.
Do you know if he has plans available,or a plan for a plane that is just foam and no covering?

I doubt he would give them to anyone. My other frame is unassembled, I could trace it...

It would be amazing if you could trace it and mark out where the control surfaces and CG are.
Thanks
Indra

Sponsored content