Log in
Search
Latest topics
» Cox Ryan ST 2.0by akjgardner Today at 5:37 pm
» Jim Walkers FireBee - This is going to be fun
by rsv1cox Today at 3:45 pm
» Hawk had breakfast and then took a bath
by GallopingGhostler Today at 2:34 pm
» Prop Rod - resto to a runner
by rsv1cox Today at 12:41 pm
» Jim Walker Firebaby
by rsv1cox Today at 12:24 pm
» Blue backplate postage stamp engine
by duaneh Today at 11:48 am
» Internet buy
by Ken Cook Today at 9:15 am
» Artwork for Otto Kuhni
by GallopingGhostler Today at 8:26 am
» Sherline lathe wont run
by getback Today at 7:15 am
» Roddie's water-cooling bottle for bench-running
by roddie Yesterday at 7:38 pm
» Feed Station Zebra.. Spring 2022
by roddie Yesterday at 5:59 pm
» **VOTE-ON-THE-NEXT-COX-ENGINE-OF-THE-MONTH** (May 2024)
by GallopingGhostler Yesterday at 11:12 am
how to remove the crank from a td 0.10.
Page 1 of 1
how to remove the crank from a td 0.10.
can anybody tell me how to remove the crankshaft from my td 0.10 , as i need to change the piston thanks,
preecy- New Member
- Posts : 1
Join date : 2015-12-02
Age : 60
Location : rugby
Re: how to remove the crank from a td 0.10.
WELCOME TO THE FORUM!
If you unscrew the back plate and cylinder, you can remove the piston and connecting rod without pulling the crankshaft.
If you unscrew the back plate and cylinder, you can remove the piston and connecting rod without pulling the crankshaft.
Kim- Top Poster
-
Posts : 8536
Join date : 2011-09-06
Location : South East Missouri
Re: how to remove the crank from a td 0.10.
You will need to use the .010 wrench to remove the cylinder. If you don't have any get a pair from Cox International or EXModel Engines.
The .010 cylinder is extremely thin at the exhaust port so you must be careful not to turn a burr into the cylinder or even deform the cylinder rendering it useless. Use of a pliers is definitely NOT recommended. Heat from a hair dryer helps if the cylinder is stuck. Carefull not to melt the tank or carb body with the heat.
Welcome to the forum.
The .010 cylinder is extremely thin at the exhaust port so you must be careful not to turn a burr into the cylinder or even deform the cylinder rendering it useless. Use of a pliers is definitely NOT recommended. Heat from a hair dryer helps if the cylinder is stuck. Carefull not to melt the tank or carb body with the heat.
Welcome to the forum.
Jason_WI- Top Poster
-
Posts : 3123
Join date : 2011-10-09
Age : 48
Location : Neenah, WI
Similar topics
» Wanted: Tee Dee .049 crank case and crank
» please remove
» Best way to remove stickers.
» Sprecken vous bollox
» Decals ; How to remove old one ?
» please remove
» Best way to remove stickers.
» Sprecken vous bollox
» Decals ; How to remove old one ?
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum